Pearson - Always learning

All your resources for Economics

RSS icon Subscribe | Text size

Posts Tagged ‘Tier 1 capital’

Too tough or not tough enough? Developing Basel III banking rules

Under the auspices of the Bank for International Settlements (BIS), banks around the world are working their way towards implementing tougher capital requirements. These tougher rules, known as ‘Basel III’, are due to come fully into operation by 2019.

This third version of international banking rules was agreed after the financial crisis of 2008, when many banks were so undercapitalised that they could not withstand the dramatic decline in the value of many of their assets and a withdrawal of funds.

Basel III requires banks to have much more capital, especially common equity capital. The point about equity (shares) is that it’s a liability that does not have to be repaid. If people hold bank shares, the bank does not have to repay them and does not even have to pay any dividends. In other words, the money raised by issuing shares carries no obligation on the part of the bank and can thus provide a buffer against large-scale withdrawal of funds.

Under Basel III, banks have to maintain sufficiently large ‘capital-adequacy ratios’. As Essentials of Economics (7th edition) explains:

Capital adequacy is a measure of a bank’s capital relative to its assets, where the assets are weighted according to the degree of risk. The more risky the assets, the greater the amount of capital that will be required.

A measure of capital adequacy is given by the capital adequacy ratio (CAR). This is given by the following formula:

Common Equity Tier 1 (CET1) capital includes bank reserves (from retained profits) and ordinary share capital (equities), where dividends to shareholders vary with the amount of profit the bank makes… Additional Tier 1 (AT1) capital consists largely of preference shares. These pay a fixed dividend (like company bonds), but although preference shareholders have a prior claim over ordinary shareholders on the company’s (i.e. the bank’s) profits, dividends need not be paid in times of loss.

Tier 2 capital is subordinated debt with a maturity greater than 5 years. Subordinated debt holders only have a claim on a company (a bank) after the claims of all other bondholders have been met.

Risk-weighted assets are the total value of assets, where each type of asset is multiplied by a risk factor. Under the Basel III accord, cash and government bonds have a risk factor of zero and are thus not included. Interbank lending between the major banks has a risk factor of 0.2 and is thus included at only 20 per cent of its value; residential mortgages under 60% of the value of the property have a risk factor of 0.35; personal loans, credit-card debt and overdrafts have a risk factor of 1; loans to companies carry a risk factor of 0.2, 0.5, 1 or 1.5, depending on the credit rating of the company. Thus the greater the average risk factor of a bank’s assets, the greater will be the value of its risk weighted assets, and the lower will be its CAR.

Basel III gives minimum capital requirements that are higher than under its predecessor, Basel II. Thus, by 2019, banks must have a common equity capital to risk-weighted assets of at least 4.5% and a Tier 1 ratio of at least 6.0%. The overall CAR should be at least 8%. In addition, the phased introduction of a ‘capital conservation buffer’ from 2016 will raise the overall CAR to at least 10.5 per cent.

Over the past few years, banks have increased their capital cushions significantly and many have exceeded the Basel III requirements, even for 2019.

But the Basel Committee has been reconsidering the calculation of risk-weighted assets. Because of the complexity of banks’ asset structures, which tend to vary significantly from country to country, it is difficult to ensure that banks’ are meeting the Basel III requirements. Under proposed amendments to Basel III (which some commentators have dubbed ‘Basel IV’), banks would have to compare their own calculations with a ‘standardised’ model. Their own calculations of risk-based assets would then not be allowed to be lower than 60–90% (known as ‘the output floor’) of the standardised approach.

While, on the surface, this may seem reasonable, European banks have claimed that this would penalise them, as some of their assets are less risky than the equivalent assets in other countries. For example, Germany has argued that mortgage defaults have been rare and thus German mortgage debt should be given a lower weighting than US mortgage debt, where defaults have been more common. If all assets were assessed according to the output floor, several banks, especially in Europe, would be judged to be undercapitalised. As The Economist article states:

Analysts at Morgan Stanley estimate that global, non-American banks could see risk-weighted assets rise by an average of 18–30%, depending on the level of the output floor. Extra capital of €250bn–410bn could be needed, a tall order when earnings are thin and investors wary. The committee’s reviews of operational and market risks would add even more.

This question of an output floor was a sticking point at the Basel Committee meeting in Santiago, which ended on 30 November. Although some progress was made about agreeing to rules on risk weighting that could be applied globally, a final agreement will have to wait until the next meeting, in January – at the earliest.

Articles
Basel bust-up: A showdown looms over bank-capital rules The Economist (26/11/16)
Bank regulators fail to agree on new rules Manila Standard (2/12/16)
Bank chief Claudio Borio urges regulators to ‘stay strong’ Weekend Australian, Michael Bennet (29/11/16)
Final Basel III rules meet resistance from Europe The Straits Times (2/12/16)
This Is the Absolutely Worst Time to Weaken Global Bank Rules American Banker, Mayra Rodriguez Valladares (2/12/16)
New Basel banking rules’ impact on European economy Financial Times, Frédéric Oudéa (28/12/16)
Banks like RBS still look risky, but getting too tough could cause greater problems The Conversation, Alan Shipman (1/12/16)

BIS publications
International banking supervisory community meets to discuss the regulatory framework BIS Press Release (1/12/16)
Basel III: international regulatory framework for banks Bank for International Settlements
Basel III phase-in arrangements Basel Committee on Banking Supervision, BIS
Basel Committee on Banking Supervision reforms – Basel III, Summary Table Basel Committee on Banking Supervision, BIS

Questions

  1. Why do reserves in banks have a zero weighting in terms of risk-based assets?
  2. What items have a 100% weighting? Explain why.
  3. Examine the table, Basel III phase-in arrangements, and explain each of the terms.
  4. If banks are forced to operate with a higher capital adequacy ratio, what is this likely to do to bank lending? Explain. How are funding costs relevant to your answer?
  5. Explain each of the items in the Basel III capital-adequacy requirements shown in the chart above.
  6. What is the American case for imposing an output floor?
  7. What is the European banks’ case for using their own risk weighting?
  8. Why is it proposed that larger ‘systemically important banks’ (SIBs) should have an additional capital requirement?
  9. How does the balance of assets of American banks differ from that of European banks?
Share in top social networks!

Basel III – tough new regulations, or letting banks off lightly?

Under the Basel II arrangements, banks were required to maintain particular capital adequacy ratios (CARs). These were to ensure that banks had sufficient capital to allow them to meet all demands from depositors and to cover losses if a borrower defaulted on payment. Basel II, it was (wrongly) thought would ensure that the banking system could not collapse.

There were three key ratios. The first was an overall minimum CAR of 8%, measured as Tier 1 capital plus Tier 2 capital as a percentage of total risk-weighted assets. As Economics 7th edition page 509 explains:

Tier 1 capital includes bank reserves (from retained profits) and ordinary share capital, where dividends to shareholders vary with the amount of profit the bank makes. Such capital thus places no burden on banks in times of losses as no dividend need be paid. What is more, unlike depositors, shareholders cannot ask for their money back. Tier 2 capital consists largely of preference shares. These pay a fixed rate of interest and thus do continue to place a burden on the bank even when losses are made (unless the bank goes out of business).

Risk-weighted assets are the value of assets, where each type of asset is multiplied by a risk factor. Under the internationally agreed Basel II accord, cash and government bonds have a risk factor of zero and are thus not included. Inter-bank lending between the major banks has a risk factor of 0.2 and is thus included at only 20 per cent of its value; residential mortgages have a risk factor of 0.35; personal loans, credit-card debt and overdrafts have a risk factor of 1; loans to companies carry a risk factor of 0.2, 0.5, 1 or 1.5, depending on the credit rating of the company. Thus the greater the average risk factor of a bank’s assets, the greater will be the value of its risk weighted assets, and the lower will be its CAR.

The second CAR was that Tier 1 capital should be at least 4% of risk weighted assets.

The third CAR was that equity capital (i.e. money raised from the issue of ordinary shares) should be at least 2% of risk weighted assets. This is known as the ‘core capital ratio’.

Before 2008, it was thought by most commentators that these capital adequacy ratios were sufficiently high. But then the banking crisis erupted. Banks were too exposed to sub-prime debt (i.e. debt that was excessively risky, such as mortgages on property at a time when property prices were rapidly declining). Much of this debt was disguised by being bundled up with other securities in what were known as collateralised debt obligations (CDOs). On 15 September 2008, Lehman Brothers filed for bankruptcy: the largest bankruptcy in history, with Lehmans owing $613 billion. Although its assets had a book value of $639, these were insufficiently liquid to enable Lehmans to meet the demands of its creditors.

The collapse of Lehmans sent shock waves around the world. Banks across the globe came under tremendous pressure. Many held too much sub-prime debt and had insufficient capital to meet creditors’ demands. As a result, they had to be bailed out by their governments. Clearly the Basel II regulations were too lax.

For several months there have been discussions about new tighter regulations and, on 12 September 2010, central bankers from the major countries met in Basel, Switzerland, and agreed the Basel III regulations. Although the overall CAR (Tier 1 and 2) was kept at 8%, the Tier 1 ratio was raised from 4% to 6% and the core Tier 1 ratio was raised from 2% to 4.5%, to be phased in by 2015. In addition there were two ‘buffers’ introduced.

As well as having to maintain a core Tier 1 ratio of 4.5%, banks would also have to hold a ‘conservation buffer’ of 2.5%. “The purpose of the conservation buffer is to ensure that banks maintain a buffer of capital that can be used to absorb losses during periods of financial and economic stress. While banks are allowed to draw on the buffer during such periods of stress, the closer their regulatory capital ratios approach the minimum requirement, the greater the constraints on earnings distributions.” In effect, then, the core Tier 1 ratio will rise from 2% to 7% (i.e. 4.5% minimum plus a buffer of 2.5%).

The other buffer is a ‘countercyclical buffer’. This will be “within a range of 0% – 2.5% of common equity or other fully loss absorbing capital and will be implemented according to national circumstances.” The idea of this buffer is to allow banks to withstand volatility in the global economy. It will be phased in between 2016 and 2019.

The Basel III agreement will still need to be ratified by the G20 countries meeting at Seoul on 10 and 11 November this year. That meeting will also consider other elements of bank regulation.

So will these extra capital requirements be sufficient to allow banks to withstand any future crisis? The following articles discuss this question.

Articles
Global bankers agree new capital reserve rules BBC News (12/9/10)
Q&A: Basel rules on bank capital – who cares? BBC News, Laurence Knight (13/9/10)
Basel III and Sound Banking New American, Charles Scaliger (17/9/10)
Wishy-washy rules might come back to haunt regulators Financial Times, Patrick Jenkins (18/9/10)
Basel III proposal released Newsweek, Joel Schectman (17/9/10)
New Bank Rules May Not Prevent More Meltdowns FXstreet, Henrik Arnt (16/9/10)
Basel III CBS Money Watch, Mark Thoma (14/9/10)
Basel III: To lend or not to lend Investment Week, Martin Morris (16/9/10)
Taming the banks The Economist (16/9/10)
Basel’s buttress The Economist (16/9/10)
Do new bank-capital requirements pose a risk to growth? The Economist, guest contributions
Myners: New rules ‘ignore bank liquidity’ BBC Today Programme, Robert Peston and Lord Myners (18/9/10)

Official press releases and documents
Group of Governors and Heads of Supervision announces higher global minimum capital standards Bank for International Settlements Press Release (12/9/10)
The Basel iii Accord Basel iii Compliance Professionals Association (BiiiCPA)
Details of the new capital requirements Bank for International Settlements
Details of the phase-in arrangements Bank for International Settlements

Questions

  1. What impact will a higher capital adequacy ratio have on banks’ behaviour?
  2. For what reasons may the Basel III regulations be considered too lax?
  3. When there is an increase in deposits into the banking sector, banks can increase loans by a multiple of this. This bank deposits multiplier is the inverse of the liquidity ratio. Is there a similar bank capital multiplier and, if so, what determines its size?
  4. Why will Basel III be phased in over a number of years? Is this too long?
Share in top social networks!